Electronics I · Diode models and rectifier circuits
An ideal independent DC source V_S=12.0 V has its positive terminal at node s and its…
Problem
Electronics I practice problemAn ideal independent DC source has its positive terminal at node and its negative terminal at the reference node . Resistor is connected from to node . A silicon diode has its anode at and its cathode at . Define and define as the current entering the anode. Use the piecewise-linear diode model: off is an open circuit requiring ; on requiresIgnore leakage, breakdown, and capacitance.
(a) Write the load-line equation relating and . Determine the open-circuit intercept and the short-circuit intercept .
(b) Intersect the load line with the on-characteristic and compute the candidate operating point . Verify the on-region inequalities. Report , , the voltage across with plus at , and the power absorbed by and by .
(c) Repeat (a) and (b) after is replaced by , with every other parameter unchanged.
(d) A laboratory partner plots the first load line as the straight segment joining to on the -- plane of the diode. Identify the coordinate error, state the correct intercepts, and determine whether that error would have changed the accepted region in (b).
Hint
HintThe load line is KVL on the source–resistor–diode loop; the diode characteristic is a second line (or an open-circuit vertical) in the same plane.
Check your work
Work the problem yourself first. Then open it in Training to check your answer and read the full worked solution.
Create a free account to check your answer and see the solution. Create a free account.
More Electronics I practice problems
- A half-wave (Greinacher) voltage doubler is assembled as followsDiode models and rectifier circuits
- A shunt clipper uses vᵢ at node A, R=3.30 kΩ from A to node B, and a pn diode with…MOSFET and BJT operation and bias
- Two identical enhancement NMOS transistors M₁ and M₂ form a large-signal current mirrorMOSFET and BJT operation and bias
- Design an NPN voltage-divider CE bias network supplied from V_(CC)=15.0 VSmall-signal models and gain
- Two otherwise identical n-channel common-source stages are biased at the same…Small-signal models and gain
- An NPN common-base amplifier is biased in forward active with the base at DC bias and…Single-stage and multistage amplifiers
- A matched NMOS source-coupled pair M₁,M₂ is biased by a tail current source I_(SS)=400…Single-stage and multistage amplifiers
- A matched NMOS pair with ideal tail I_(SS)=0.500 mA and drain resistors…Device and amplifier frequency response
- A series-shunt discrete amplifier uses a loaded open-loop DC gain A=640 V/V that is…Feedback, stability, and practical op-amp limits