Skip to main content

Electronics I · Single-stage and multistage amplifiers

A matched NMOS source-coupled pair M₁,M₂ is biased by a tail current source I_(SS)=400…

Problem

Electronics I practice problem

A matched NMOS source-coupled pair M1,M2M_1,M_2 is biased by a tail current source ISS=400 μAI_{SS}=400\,\mu\mathrm{A} in parallel with a finite small-signal resistance RSS=50.0 kΩR_{SS}=50.0\,\mathrm{k}\Omega from the common source node to ground. Each drain is loaded by RD=6.00 kΩR_D=6.00\,\mathrm{k}\Omega to VDD=3.30 VV_{DD}=3.30\,\mathrm{V}. The saturation law is iD=kn(vGS−Vtn)2i_D=k_n(v_{GS}-V_{tn})^2 with kn=12μnCox(W/L)k_n=\tfrac12\mu_n C_{\mathrm{ox}}(W/L), μnCox=180 μA/V2\mu_n C_{\mathrm{ox}}=180\,\mu\mathrm{A}/\mathrm{V}^2, W/L=25.0W/L=25.0, Vtn=0.600 VV_{tn}=0.600\,\mathrm{V}, and λ=0\lambda=0. Substrates of M1M_1 and M2M_2 are tied to the common source. Definevid=vG1−vG2,vicm=12(vG1+vG2),vod=vD1−vD2.v_{id}=v_{G1}-v_{G2},\qquad v_{icm}=\tfrac12(v_{G1}+v_{G2}),\qquad v_{od}=v_{D1}-v_{D2}.Use the standard MOS small-signal model id=gmvgsi_d=g_m v_{gs} with gmg_m evaluated at ID=ISS/2I_D=I_{SS}/2. Ignore ror_o of M1M_1 and M2M_2.

(a) Draw and label the differential half-circuit and the common-mode half-circuit. State the value of the source degeneration seen in each half-circuit.

(b) Derive and evaluate the differential voltage gain Ad=vod/vidA_d=v_{od}/v_{id} and the single-ended common-mode gain Acm,se=vo1/vicmA_{cm,\mathrm{se}}=v_{o1}/v_{icm}. Then form the single-ended common-mode rejection ratio CMRRse=∣Ad/2∣/∣Acm,se∣\mathrm{CMRR_{se}}=\lvert A_d/2\rvert/\lvert A_{cm,\mathrm{se}}\rvert and the fully differential CMRR ∣Ad∣/∣Acm∣\lvert A_d\rvert/\lvert A_{cm}\rvert where Acm=vod/vicmA_{cm}=v_{od}/v_{icm} for matched loads. Report CMRR as a dimensionless ratio and in decibels.

(c) Explain, without numerical guesswork, why a perfectly matched pair with matched drain resistors has Acm=vod/vicm=0A_{cm}=v_{od}/v_{icm}=0 even when RSSR_{SS} is finite, and identify the single element mismatch that would produce a nonzero vodv_{od} under a pure common-mode input. Do not introduce a numerical mismatch in this part.

Hint

Hint

Odd-mode symmetry kills the tail node; even-mode symmetry doubles the tail resistor in the half-circuit.

Check your work

Work the problem yourself first. Then open it in Training to check your answer and read the full worked solution.

The answer check and full solution for this problem come with ProofAnvil Practice membership ($19 USD monthly). See membership. Or start with the free Electronics I sample problem: Try the free sample problem.

More Electronics I practice problems

Back to Electronics I

An original ProofAnvil practice problem, written for this course. ProofAnvil is a practice course, not a homework-answer service.