Electronics I · Device and amplifier frequency response
A matched NMOS pair with ideal tail I_(SS)=0.500 mA and drain resistors…
Problem
Electronics I practice problemA matched NMOS pair with ideal tail and drain resistors to is used as a fully differential amplifier. Device at the balanced point, . A small-signal disturbance appears on the rail (positive-supply ripple) while the input gates are AC-grounded in the differential sense () and held at a fixed common-mode voltage with infinite bypass to the signal ground used for .
(a) If exactly, determine . Explain using symmetry.
(b) Now and (a +2.00% mismatch on only). With the tail still ideal and the sources of joined, determine the small-signal . Treat the pair as two CS devices whose sources are not AC ground: first compute the common source-node voltage, or equivalently use superposition with matched and the first-order mismatch. Report the numerical PSRR of the differential output, , as a ratio and in decibels.
(c) The same 2.00% drain-resistor mismatch is now assessed for a purely common-mode gate input with a tail resistance and a clean . Using(or an exact half-circuit equivalent you derive), evaluate and compare its magnitude with of part (b). Interpret which disturbance is more dangerous for this particular mismatch.
Hint
HintWith a MOSFET drain current does not care about the drain voltage; unmatched cannot create a current mismatch by itself.
Check your work
Work the problem yourself first. Then open it in Training to check your answer and read the full worked solution.
The answer check and full solution for this problem come with ProofAnvil Practice membership ($19 USD monthly). See membership. Or start with the free Electronics I sample problem: Try the free sample problem.
More Electronics I practice problems
- An ideal independent DC source V_S=12.0 V has its positive terminal at node s and its…Diode models and rectifier circuits
- A half-wave (Greinacher) voltage doubler is assembled as followsDiode models and rectifier circuits
- A shunt clipper uses vᵢ at node A, R=3.30 kΩ from A to node B, and a pn diode with…MOSFET and BJT operation and bias
- Two identical enhancement NMOS transistors M₁ and M₂ form a large-signal current mirrorMOSFET and BJT operation and bias
- Design an NPN voltage-divider CE bias network supplied from V_(CC)=15.0 VSmall-signal models and gain
- Two otherwise identical n-channel common-source stages are biased at the same…Small-signal models and gain
- An NPN common-base amplifier is biased in forward active with the base at DC bias and…Single-stage and multistage amplifiers
- A matched NMOS source-coupled pair M₁,M₂ is biased by a tail current source I_(SS)=400…Single-stage and multistage amplifiers
- A series-shunt discrete amplifier uses a loaded open-loop DC gain A=640 V/V that is…Feedback, stability, and practical op-amp limits