Circuits I · Phasors, sinusoidal steady state, and AC power
A three-phase source is balanced and positive-sequence
Problem
Circuits I practice problemA three-phase source is balanced and positive-sequence. Line-to-neutral RMS phasors, with phase as the angle reference, areA balanced Y-connected load has phase impedancein each of , , and , with the common neutral connected to the source neutral by an ideal conductor. All voltages and currents in this packet are RMS phasors. Passive sign convention: each phase current enters the corresponding load impedance from the line terminal.
1. Compute in polar form. Then write and by the positive-sequence shifts and . Use the conventional engineering angle .
2. Form the line-to-line voltage and prove3. Compute the total complex power , the apparent power , and the power factor, including lag/lead.
4. Give the equivalent balanced delta impedance that draws the same line currents from the same line voltages.
5. Audit both sentences: (i) “the source is a peak phasor, so every current and the total power must be scaled by or ”; (ii) “the equivalent delta is .” Do not replace the packet by a single-phase series- complex-power balance or a frequency-response resonance argument.
Hint
Hintand , so A.
Check your work
Work the problem yourself first. Then open it in Training to check your answer and read the full worked solution.
The answer check and full solution for this problem come with ProofAnvil Practice membership ($19 USD monthly). See membership.
More Circuits I practice problems
- A charge q=50 μC is moved slowly from node n to node pVoltage, current, power, and resistive networks
- A connected resistive network has three essential nodes labelled A, B, and NVoltage, current, power, and resistive networks
- A network has essential nodes A, B, C, and reference node NNode, mesh, superposition, and equivalent circuits
- A connected planar circuit occupies two adjacent rectangular windows whose shared…Node, mesh, superposition, and equivalent circuits
- A linear one-port has terminals t and the reference node (ground)Ideal operational-amplifier circuits
- An ideal operational amplifier with supplies ±15.0 V (saturation at the rails) is…Ideal operational-amplifier circuits
- Capacitors C₁=20 μF and C₂=30 μF are connected in seriesCapacitors, inductors, and first-order transients
- A 40 μF capacitor is connected, for all t<0 and for a duration sufficient to reach DC…Capacitors, inductors, and first-order transients
- A source-free parallel circuit consists of R = 8 Ω, L = 2 H, and C = 1/32 FSecond-order natural and step responses